Planning/Configuring; Fast Setup: Control The Drive Using The Default Configuration - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

6.4

Planning/Configuring

This section describes the setup methods available for communication. The following topics
are explained:
● Fast setup procedures
● PLC setup
● Network setup procedure
● Network status detection
● An example to illustrate the setup procedure.
Note
Fast setup procedures allow setup of a Network 1 interface with a minimum of detail.
6.4.1

Fast Setup: Control the drive using the default configuration

To control the drive using the default configuration, you must send commands to the drive's
'fixed reg bits' location. This location is register 'Data to Drive 01' as provided in Table
Correspondence between Drive Parameter ID and Communication Protocol Address in
Section
To control the drive from a PLC using the default configuration, complete the following steps.
1. Set parameter 'Network 1 Type' (9901) to "Profibus".
2. Set parameter 'Profibus Address' (9904) to the desired network address for the drive.
3. Set parameter 'Net Control Type' (9944) to "Fixed". This sets the bits at register 'Data to
Drive 01' where the fixed register bits are located. The fixed register bits are interpreted as
shown in the following table.
4. Add the following line to the SOP:
Network1RunEnable_O = TRUE;
Table 6-20
Bit
Network1FixedRegBit0_I
Network1FixedRegBit1_I
Network1FixedRegBit2_I
Network1FixedRegBit3_I
Network1FixedRegBit4_I
Network1FixedRegBit5_I
Network1FixedRegBit6_I
NXGpro Communication
Function Manual, AB, A5E33486415A
Parameter Assignment/Addressing .
Default definitions of Fixed Register Bits
Profibus Communication
6.4 Planning/Configuring
Default Definition
Run forward
Run reverse
Fault reset
Stop
1
Reserved
Start stop control from network
Speed commanded from network
155