Table 9-1 Status Indicator Descriptions - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

Connector
The module is equipped with two BNC contacts (Channel A and Channel B) for connection to
ControlNet™ as follows:
● For redundant operation: use both Channel A and Channel B connectors
● Otherwise: use connector Channel A or Channel B.
MacID Switches
The MacID switches must both ALWAYS be set to 0, to allow the control software to set the
MacID from the menu.
Status Indicators
The following figure shows the status indicators.
Figure 9-2
The table explains the status indicators.
Table 9-1 Status Indicator Descriptions
Status Indicator Indication
(figure number)
1 Module status
2 and 3 Channel A and
Channel B
2 or 3 Channel A or
Channel B
4 Module owned
NXGpro Communication
Function Manual, AB, A5E33486415A
Status Indicators
State
Green
Green, flashing
Red
Red, flashing
Off
Green/red, alternating Self-test
Red
Red, flashing
Off
Green
Green, flashing
Red, flashing
Red/green, flashing
Off
Green
Description
Connection in Run State.
Connecting Connection Idle.
Major fault
Minor fault
Module not initialized.
Major fault
Node configuration error. For example: duplicate MAC ID.
Channel disabled.
Normal operation of channel.
Temporary error (node will self correct) or not configured.
No other nodes, or media fault
Network configuration error.
No connection has been opened.
A connection has been opened towards the module.
ControlNet Communication
9.1 Description
219