Parameter Assignment/Addressing; Correspondence Between Drive Parameter Id And Communication Protocol Address - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

ProfiDrive Communication

7.2 Parameter Assignment/Addressing

7.2 Parameter Assignment/Addressing
This section provides the following information for communication configuration and
programming:
● Drive parameter ID and corresponding communication protocol address
● Parameter tables:
– Network configuration parameters
– Network 1 configuration parameters
– Network 2 configuration parameters
● Pick list variable tables:
– Data from Drive variables
– Data to Drive variables
● Telegram data tables:
– Supported telegrams
– Detail of each telegram
– Signal description
– Signal bit description
– Supported parameters
7.2.1 Correspondence between Drive Parameter ID and Communication Protocol
Address
The following table provides drive parameter IDs and the corresponding ProfiDrive™ telegram.
The following data is provided:
● Parameter ID
The drive parameter ID number to enter via the keypad or the ToolSuite.
● ProfiDrive™ Telegram
The drive software supports ProfiDrive™ telegrams as listed in Table
ProfiDrive™ Telegrams . Refer to the table for each supported telegram for related signal
names for the "To Drive" and "From Drive" data. Configure Telegrams 998 and 999 via the
menu system as described in Section
352 do not require menu configuration.
168
Network Setup Procedure . Telegrams 1, 2, 20 and
Function Manual, AB, A5E33486415A
Supported
NXGpro Communication