Setup Example - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

Ethernet / IP Communication
5.5 Planning/Configuring
5. Use Table
Address in Section Parameter Assignment/Addressing to program the drive to send data
to and receive commands from the network. The table provides all available addresses with
corresponding parameter ID as well as pre-programmed addresses, which provide basic
drive send and receive functionality and are not changeable.
6. Define the bits in the available addresses using one of the following methods:
● Enter from a choice of variables in the pick lists. The pick lists in the menus contain the
most commonly used data variables. Refer to Section
for the pick lists.
Note
A pick list item can only be used once for each 'Data to Drive' register.
● For 'Data from Drive' registers, choose pick list option "Man Id" (manual ID) to manually
enter a variable that is not included in the pick lists, using the output data ID number. Use
the list of data IDs available in Appendix
corresponding ID number to enter the variable into the 'Data from Drive' register.
Note
The output data ID number is not the same as a parameter ID number.
● Custom program using the drive's SOP. Refer to Section
Note
The PLC can receive data from the drive without any changes to the SOP.
Only if you need to control the drive through the network will you need to set any flags in
the SOP.
See also
Output Data IDs (Page 277)
Software Programming (Page 112)
5.5.10

Setup Example

Task
Set up network to indicate the following drive outputs on the PLC:
● general status
● motor speed
● output power
● number of active faults.
132
Correspondence between Drive Parameter ID and Communication Protocol
Parameter Assignment/Addressing
Output Data IDs to locate the variable and use the
Software Programming for details.
Function Manual, AB, A5E33486415A
NXGpro Communication