Fitting The Rs-232C Signal Cable; Initializing The Kmas - Kyocera TASKalfa 4500i Service Manual

15. Wrap the PHS signal cable around the
ferrite core a turn.
16. Connect the connector of the PHS sig-
nal cable to PHS module.
17. Fit the clamp to PHS signal cable.
18. After using alcohol to clean the rear
upper cover, adhere the clamp to rear
upper cover.

Fitting the RS-232C signal cable

1. By referring to the instructions given to
fix the PHS signal wire, insert the con-
nector at the end of the RS-232C relay
cable to the YC3 connector on the
KMAS interface PWB.
If the wire length is short, use a RS-
232C extension cable.
2. Connect the RS-232C signal cable to
the modem.

Initializing the KMAS

1. Turn the main power switch on and
enter the maintenance mode.
2. Run maintenance item U202 and Per-
forms [Init/Set TEL No.] (see page 1-3-
93).
3. Exit the maintenance mode.
PHS module
Clamp
Figure 1-2-75
1-2-58
Ferrite core
PHS signal cable
PHS signal cable
2LL/2LJ/2LH