Firmware Environment Commands; Using Frpo Commands For Reprogramming Firmware; Frpo Parameters - Kyocera TASKalfa 4500i Service Manual

(5) Firmware environment commands

The printer maintains a number of printing parameters in its memory. There parameters may be changed per-
manently with the FRPO (Firmware RePrOgram) commands.
This section provides information on how to use the FRPO command and its parameters using examples.

Using FRPO commands for reprogramming firmware

The current settings of the FRPO parameters are listed as optional values on the service status page.
Note: Before changing any FRPO parameter, print out a service status page, so you will know the parameter
values before the changes are made. To return FRPO parameters to their factory default values, send the
FRPO INIT (FRPO-INITialize) command.(!R! FRPO INIT; EXIT;)
The FRPO command is sent to the printer in the following sequence:
!R! FRPO parameter, value; EXIT;
Example: Changing emulation mode to PCL6
!R! FRPO P1, 6; EXIT;

FRPO parameters

Item
Top margin
Left margin
Page length
Page width
Default pattern resolution
Page orientation
Default font No. *
PCL font switch
Total host buffer size
Form feed time-out value
Top margin
Left margin
FRPO
A1 Integer value in inches
A2 Fraction value in 1/100 inches
A3 Integer value in inches
A4 Fraction value in 1/100 inches
A5 Integer value in inches
A6 Fraction value in 1/100 inches
A7 Integer value in inches
A8 Fraction value in 1/100 inches
B8 0: 300 dpi
1: 600 dpi
C1 0: Portrait
1: Landscape
C2 Middle two digits of power-up font
C3 Last two digits of power-up font
C5 First two digits of power-up font
C8 0: HP compatibility mode
32: Conventional compatibility mode
H8 0 to 99 in units of the size defined by FRPO S5
H9 Value in units of 5 seconds (1 to 99)
L1 Top margin (integer value)
L2 Top margin (decimal value)
L3 Left margin (integer value)
L4 Left margin (decimal value)
2-4-9
Setting values
2LL/2LJ/2LH
Factory
setting
0
0
0
0
17
30
17
30
0
0
0
0
0
0
5
6 (30 s)
0
50
0
50