Fitting The Phs Signal Cable And Phs Module; Edging - Kyocera TASKalfa 4500i Service Manual

Hide thumbs Also See for TASKalfa 4500i:

Table of Contents

8. Pass the KMAS wire through the edging

of the controller box and wire saddle

and then fasten the KMAS wire.

Fitting the PHS signal cable and PHS mod-

9. Remove two screws and then remove

the lid from the rear upper cover.

10. Pass the PHS signal cable through the

aperture in the rear upper cover.

11. Secure the PHS signal cable to rear

upper cover with two screws.

Figure 1-2-71

Rear upper cover

PHS signal cable

Figure 1-2-72

Show Quick Links

Table of Contents

Taskalfa 3500i Taskalfa 5500i