Detaching The Separation Pulley - Kyocera TASKalfa 4500i Service Manual

Detaching the separation pulley

9. Remove the spring.
10. Remove the retard holder from the pri-
mary lower plate.
11. Remove the separation pulley from the
retard holder.
12. Clean or replace the forwarding pulley,
paper feed pulley and separation pulley.
13. Refit the forwarding pulley, paper feed
pulley and separation pulley to the pri-
mary paper feed unit.
14. When the forwarding pulley, paper feed
pulley or separation pulley is replaced,
perform maintenance mode U903
(clearing the jam counter) (see page 1-
3-162).
Spring
Primary lower plate
Figure 1-5-13
Separation pulley
Axis hole
Figure 1-5-14
1-5-9
2LL/2LJ/2LH-1
Hole
Hole
Retard holder
Axis hole
Retard holder