Setting For Toner Applying Operation - Kyocera TASKalfa 4500i Service Manual

Item No.
U147

Setting for toner applying operation

Description
Sets the mode for removing charged toner in the developing unit (T7 control: Toner applying
operation).
Purpose
The setting can be changed to reduce the toner applying quantity.
If the charged toner stays inside the developing unit, density decreases.
Method
1. Press the start key.
2. Select the item to be set.
Display
Timing
Mode
Upper Limit
Minimum
Setting: [Upper Limit]
1. Change the setting value using the +/- keys or numeric keys.
Display
Paper Int
Job End
2. Press the start key. The value is set.
Setting: [Mode]
1. Select the mode.
Display
Mode0
Mode1
Initial setting; Mode1
2. Press the start key. The setting is set.
Setting timing to transit to toner applying
Settings for toner applying operation
Upper limit printing ratio of toner applying quantity with each mode
Toner layer width when cleaning mode is selected
Description
Setting number of pages to transit
to toner applying (between pages)
Setting number of pages to transit
to toner applying (job completed)
Less consumption of toner than a regular toner applying operation
Executes toner applying with the regular amount of toner
1-3-84
Description
Description
Setting
range
0 to 100
0 to 100
Description
2LL/2LJ/2LH-1
Initial setting
35ppm 45ppm 55ppm
35 45 55
8 8 8