Detaching And Refitting The Fuser Drive Unit And Feed Drive Unit - Kyocera TASKalfa 4500i Service Manual

Hide thumbs Also See for TASKalfa 4500i:

Table of Contents

(3) Detaching and refitting the fuser drive unit and feed drive unit

Detaching the fuser drive unit

1. Remove the rear upper cover and the

rear lower cover (see page 1-5-57).

2. Remove five wire holders of feed PWB

3. Release two wire saddles.

4. Remove the following twenty two con-

nectors from the feed PWB 1.

YC1 (FFC connector with a lock)

YC2 (FFC connector with a lock)

*: When removing the FFC from the FFC

connector with a lock, remove the FFC

after released by lifting down the lock

lever (see page 1-5-42).

Figure 1-5-106

Figure 1-5-107

2LL/2LJ/2LH-1

FFC connector

Show Quick Links

Table of Contents

Taskalfa 3500i Taskalfa 5500i