Refitting The Isu - Kyocera TASKalfa 4500i Service Manual

6. Remove four screws and then remove
the ISU.

Refitting the ISU

7. Decide the fix position of ISU by the fol-
lowing.
The right and left of machine:
Verify the number prefixed by a (c)
mark.
Match the line (c) of ISU to the position-
ing line (b) of same number on frame
side.
The rear and front of machine:
Match the edge (e) of ISU to the posi-
tioning line (d) on frame side.
8. Fix the ISU as before with four screws.
9. Refit all the removed parts.
10. When replacing the new ISU, performs
maintenance mode U411 (Adjusting the
scanner automatically)
(see page 1-3-139).
Screw
13579
Screw
b
135 79
e
d
1-5-23
2LL/2LJ/2LH-2
ISU
Figure 1-5-39
Lens
c
ISU
Figure 1-5-40
Screw
Screw
a