Setting Of Deflection For Feeding From Dp - Kyocera TASKalfa 4500i Service Manual

Item No.
U942

Setting of deflection for feeding from DP

Description
Adjusts the deflection generated when the document processor is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the
document processor is used.
Setting
1. Press the start key.
2. Press the system menu key.
3. Place an original on the DP and press the start key to make a test copy.
4. Press the system menu key.
5. Select the item to be adjusted.
6. Change the setting value using the +/- keys or numeric keys.l
Display
Front
Back*
Mix
*1: Reversed DP only.
* : The greater the value, the larger the deflection; the smaller the value, the smaller the
deflection.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling
of original occurs, decrease the value.
7. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Description
Deflection of single-sided original
Deflection of double-sided original
Deflection of mixed original
1-3-173
Description
Setting
range
-31 to 31
-31 to 31
-31 to 31
2LL/2LJ/2LH-1
Initial Change in
setting value per step
0 0.17 mm
0 0.17 mm
0 0.17 mm