Setting For Toner Applying Operation; Checking Sensors For Toner - Kyocera FS-6525MFP Service Manual

Item No.
U147

Setting for toner applying operation

Description
Sets the mode for removing charged toner in the developer unit (T7 control: Toner applying oper-
ation).
Purpose
Changing settings are not required. However, when the documents with lower print density (e.g.
less than 2%) should customarily printed in a great volume, mode must be changed.
If the charged toner stays inside the developer unit, density decreases.
Setting
1. Press the start key
2. Select the item to be set.
Mode0
Mode1
* : Initial setting; Mode1
3. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U150

Checking sensors for toner

Description
Displays the on-off status of each sensor or switch related to toner.
Purpose
To check if the sensors and switches operate correctly.
Method
1. Press the start key.
2. Turn each switch or sensor on and off manually to check the status.
When a switch or sensor is detected to be in the ON position, the display for that switch or
sensor will be "1"
Container Set
Container Sensor
Waste Box Sensor
Motor
3. To stop motor driving, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Display
Normal mode
Toner consumption mode
Display
Toner container switch (TCSW)
Toner sensor (TS)
Waste toner sensor (WTS)
Main motor (MM) is turned on
Description
Description
Switches and sensors
1-3-46
2MW/2MX