Tools And Parts Required To Remove Components From A T640 Router - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
Related
Documentation

Tools and Parts Required to Remove Components from a T640 Router

378
For product problems or technical support issues, contact the Juniper Networks Technical
Assistance Center (JTAC) using the Case Manager link at
or at 1-888-314-JTAC (within the United States) or 1-408-745-9500 (from outside the
United States).
When you need to return a component:
Determine the part number and serial number of the component.
1.
Obtain a Return Materials Authorization (RMA) number from the Juniper Networks
2.
Technical Assistance Center (JTAC). You can send e-mail or telephone as described
above.
Provide the following information in your e-mail message or during the telephone call:
3.
Part number and serial number of component
Your name, organization name, telephone number, and fax number
Description of the failure
The support representative validates your request and issues an RMA number for
4.
return of the component.
Pack the router or component for shipment.
5.
T640 Router Description on page 3
T640 Chassis Description on page 13
Locating T640 Component Serial Numbers Using the CLI on page 369
Packing the T640 Router for Shipment on page 379
To remove components from the router or the router from a rack, you need the following
tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
7/16-in. (11 mm) nut driver
Blank panels to cover empty slots
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic interfaces or cable
Wire cutters
http://www.juniper.net/support/
Copyright © 2010, Juniper Networks, Inc.
,