Suzuki Liana RH413 Service Manual page 1037

15) Disconnect deployment harness from 12 volts
vehicle battery (2) and short two deployment
harness leads together by fully seating one banana
plug into the other.
16) In the unlikely event that air bag (inflator) module or
seat belt pretensioner did not deploy / activate after
following these procedures, proceed immediately
with Step 23) through 26). If air bag (inflator) module
or seat belt pretensioner did deploy or activate,
proceed with Steps 18) through 22).
17) Put on pair of shop gloves to protect your hands from
possible irritation and heat when handling deployed
air bag (inflator) module or activated seat belt
pretensioner.
18) Disconnect adapter cable (special tool) from air bag
(inflator) module or seat belt pretensioner as soon as
possible. This will prevent adapter cable (special
tool) from damage due to possible contact with hot
air bag (inflator) module or hot seat belt
pretensioner.
19) Check adapter cable connector as follows.
Adapter cable connector (special tool) is designed to
be reused. However it should be inspected for
damage after deployment and replaced if necessary.
20) Dispose of deployed air bag (inflator) module (1) or
activated seat belt pretensioner (2) through normal
refuse channels after it has cooled for at least 30
minutes and tightly seal air bag (inflator) module (1)
or seat belt pretensioner (2) in strong vinyl bag.
Refer to "Deployed Air Bag (Inflator) Module and
Activated Seat Belt Pretensioner Disposal" in detail.
21) Wash your hands with mild soap and water
afterward.
NOTE
Remaining steps are to be followed in the
unlikely event that air bag (inflator) module
did not deploy or seat belt pretensioner did
not activate.
22) Ensure that deployment harness has been
disconnected from 12 volts vehicle battery and that
I2RH01820069-01
its two banana plugs have been shorted together by
fully seating one banana plug into the other.
23) Disconnect deployment harness and adapter cable
from air bag (inflator) module or seat belt
pretensioner.
24) Temporarily store undeployed air bag (inflator)
module or unactivated seat belt pretensioner
referring to "Precautions on Service and Diagnosis
of Air Bag System" or "Precautions on Service and
Diagnosis of Seat Belt in Section 8A" for details.
25) Contact your local distributor for further assistance.
Deployment / Activation Inside of Vehicle
When the vehicle will be destroyed, or salvaged for
component parts, deploy the air bag modules and/or
activate seat belt pretensioners installed on vehicle.
1) Turn ignition switch to "LOCK" position, remove key
and put on safety glasses.
2) Remove all loose objects from front seats and
instrument panel.
3) Disconnect air bag (inflator) module or seat belt
pretensioner connector as follows.
a) For driver air bag (inflator) module
Disconnect contact coil connector (1) located
near base of steering column.
b) For passenger air bag (inflator) module
Remove glove box from instrument panel and
disconnect passenger air bag (inflator) module
connector (2).
c) For side air bag (inflator) module
Disconnect side air bag (inflator) module
connectors (3) under front seat cushion.
d) For seat belt pretensioner
Remove both side (driver and passenger side)
center pillar lower trims and disconnect seat belt
pretensioner connectors (3).
I2RH01820070-01
Air Bag System: 8B-112