Passenger Air Bag (Inflator) Module Inspection - Suzuki Liana RH413 Service Manual

2
1
2) Tighten passenger air bag (inflator) module attaching
bolts (1) to specified torque and screws (2).
Tightening torque
Passenger air bag (inflator) module attaching
bolt (a): 23 N·m (2.3 kgf-m, 16.5 lb-ft)
3) Connect passenger air bag (inflator) module
connector (1) securely as shown in the figure.
a) Connect connector.
b) Lock connector with lock button (2).
2
4) Install blower unit and fresh air inlet duct referring to
"Blower Unit Removal and Installation in Section 7A".
5) Enable air bag system. Refer to "Enabling Air Bag
System".
1
I3RH0A820068-01
2
1, (a)
I3RH0A820069-01
b)
a)
1
I3RH0A820070-01

Passenger Air Bag (Inflator) Module Inspection

WARNING
!
• Never attempt to disassemble or repair the
passenger air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System" before
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or
undeployment of the air bag when
necessary.
• Never measure resistance of passenger air
bag (inflator) module or disassemble it.
Otherwise personal injury may result.
CAUTION
!
If air bag (Inflator) module was dropped from
a height of 90 cm (3 ft) or more, it should be
replaced.
Check air bag (inflator) module appearance visually for
following symptoms and if any one of them is applicable,
replace with a new one.
• Air bag has deployed.
• Wire harness or connector is damaged.
• Air bag (inflator) module is damaged or a strong
impact was applied to it.
Air Bag System: 8B-104
S3RH0A8206008
I3RH0A820071-01