9B-11 Lighting Systems:
Turn Signal and Hazard Relay Inspection
Connect turn signal and hazard relay (1), battery (3) and
two test bulbs (12 V, 27 W) (2) as shown.
Unless a continued flash on and off is visible, replace
relay.
Reference flashing cycle
60 – 120 cycle/minute
License Lamp Assembly (for Wagon Model)
Removal and Installation
Removal
1) Remove back door garnish referring to "Rearend
Door Assembly (for Wagon Model) Removal and
Installation in Section 9J".
2) Remove licence lamp lens (1), licence lamp bulb (2)
and licence lamp socket cover (3).
2
1
S3RH0A9206013
I2RH01920015-01
S3RH0A9206014
3
I2RH01920021-01
3) Using flat head screw driver or the like (1), push
locking part of licence lamp socket (2). And then,
remove licence lamp socket (2) as shown.
CAUTION
!
To prevent vehicle body from scratch, wrap
flat head screw driver or the like (1) with tape.
Installation
Reverse removal procedure.
Front Fog Light Assembly Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper. Refer to "Front Bumper and
Rear Bumper Components in Section 9K".
3) Disconnect couplers (1) from fog light (2).
4) Detach fog light (2) pushing clips (3) to arrow
direction.
3
Installation
Reverse removal procedure.
2
1
I2RH01920022-01
S3RH0A9206015
3
2
1
I2RH01920018-01