Front Door Window Regulator Removal And Installation - Suzuki Liana RH413 Service Manual

9E-9 Glass / Windows / Mirrors:
4) Remove door sealing cover (1).
1
5) Remove outer weather-strip (1). Do not deform it
when removal.
Lower window all the way down. Then, use a tape-
wrapped putty knife to pry off outer weather-strip.
6) Remove door glass mounting screws (1).
7) Remove door glass (2) while tilting it as shown.
2
1
Installation
Reverse removal procedure noting the following
instructions.
• If there is deformity for glass run, replace it with a new
one.
• Tighten door glass rear mounting screw (1) first, and
then tighten door glass front mounting screw (2).
I2RH01950017-01
1
2
I2RH01950018-01
2
I4RH01950007-01
1
2
• Secure door sealing cover (1) with adhesive (2).
1
2
• Tighten front door outer weather-strip mounting screw
to specified torque.
Tightening torque
Front door outer weather-strip mounting screw
((a)): 1.5 N·m (0.15 kgf-m, 1.0 lb-ft)
Front Door Window Regulator Removal and
Installation
Removal
1) Remove door glass referring to "Front Door Glass
Removal and Installation".
2) Disconnect power window motor lead wire at coupler
and loosen clamp.
3) Loosen regulator mounting bolts (1) and nuts (2),
and then remove front door window regulator (3).
I2RH01950020-01
I2RH01950022-01
(a)
I2RH01950023-01
S3RH0A9506005