Oil Pressure Switch Removal and Installation
Refer to "Oil Pressure Check in Section 1E".
Oil Pressure Switch On-Vehicle Inspection
1) Disconnect oil pressure switch (1) lead wire.
2) Check for continuity between oil pressure switch
terminal (2) and cylinder block (3) as shown.
If check result is not as specified, replace oil
pressure switch (1).
Oil pressure sensor specification
During engine running: No continuity
At engine stop: Continuity
VSS Removal and Installation
S3RH0A9306006
Refer to "Vehicle Speed Sensor (VSS) Removal and
Installation in Section 5B".
S3RH0A9306007
VSS Inspection
Refer to "Vehicle Speed Sensor (VSS) and Its Circuit
Inspection in Section 1C".
Engine Coolant Temperature (ECT) Sensor
Inspection
Warm up sender gauge. Thus make sure its resistance
is decreased with increase of its temperature.
If check result is not as specified, replace sensor.
ECT sensor specification (Temperature: Resistance)
20 °C (68 °F): 2.28 – 2.63 kΩ
80 °C (176 °F): 305 – 331 Ω
Brake Fluid Level Switch Inspection
Check for continuity between terminals of brake fluid
level switch coupler (1). If found defective, replace
switch.
Brake fluid level switch specification
OFF position (float up): No continuity
I3RH0A930003-01
ON position (float down): Continuity
Instrumentation / Driver Info. / Horn:
1. ECT sensor
9C-12
S3RH0A9306008
S3RH0A9306009
S3RH0A9306010
I2RH01930007-01
S3RH0A9306011
I2RH01930009-01