Switches; Transfer 4Wd Switch Removal And Installation; Back Up Light Switch Removal And Installation - Suzuki Grand Vitara XL-7 Service Manual

7A2-8 MANUAL TRANSMISSION

SWITCHES

TRANSFER 4WD SWITCH REMOVAL AND
INSTALLATION
1) Remove console box and lift transmission control lever boots
No.2 and No.3. (Refer to "SHIFT CONTROL LEVERS" in this
section.)
2) Remove transfer control lever boot No.2 (3), unclamp wiring on
transfer case to free it and pull off coupler (1).
3) Replace 4WD switch (2) and connect as it was.
Tightening torque
4WD switch (a): 20 N
4) Turn ON ignition switch, shift transfer shift control lever to 4WD
position and check that indicator lights. Turn OFF switch after
checking.
NOTE:
D When removing and reinstalling switch, use care not to let
dust enter transfer box inside.
D Make sure to reset clamp for wiring which is located
where invisible directly.
D It is recommended to work on transfer shift control lever
boot No.1 from underside of vehicle on lift.
D Identify this 4WD switch (2) by its leg part which is differ-
ent for that of back up light switch (1).
BACK UP LIGHT SWITCH REMOVAL AND
INSTALLATION
WARNING:
Refrain from work while exhaust center pipe is hot.
NOTE:
When replacing switch, use care not to let dust enter transmis-
sion through switch hole.
1) Lift up vehicle.
2) Remove coupler(s) (1) for switch wiring.
.
m (2.0 kg-m, 14.5 lb-ft)