Rear Wiper Motor (If Equipped) Inspection; Windshield Wiper And Washer Switch Removal And Installation - Suzuki Liana RH413 Service Manual

4) Repeat Step 1) to 3) several times and check that
the motor stops at the specified position every time.
If check result is not satisfied, replace motor.

Rear Wiper Motor (If Equipped) Inspection

NOTE
Make sure that battery voltage is 12 V or
more.
Motor Operation
1) Connect battery positive terminal to terminal "L" and
its negative terminal to terminal "E".
2) Check motor revolution speed as specification. If
check result is not as specified, replace motor.
Specification
35 – 45 r/min (rpm)
Automatic Stop Operation
1) Connect battery positive (+) terminal to terminal "L"
and its negative (–) terminal to terminal "E" and let
the motor turn.
2) Disconnect terminal "L" from battery positive (+)
terminal and let the motor stop.
3) Connect terminal "B" to battery positive (+) terminal.
Observe the motor turns once again then stops at a
specified position.
4) Repeat Step 1) to 3) several times and check that
the motor stops at the specified position every time.
If check result is not satisfied, replace motor.
Windshield Wiper and Washer Switch Removal
and Installation
Removal
1) Disconnect negative (–) cable at battery.
S3RH0A9406005 2) Remove steering column hole cover (1).
3) Remove steering column covers (2).
Turn steering wheel to access steering column cover
rearend screws.
4) Remove windshield wiper and washer switch (1)
from combination switch assembly (2) and
disconnect its coupler (3).
Installation
Reverse removal procedure.
I2RH01940012-01
Wipers / Washers:
2
1
9D-4
S3RH0A9406006
I4RH01920003-01
I2RH01940002-01