Switch Port Commands - D-Link DES-3550 Command Line Interface Reference Manual

The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config ports
show ports
Each command is listed, in detail, in the following sections.
DES-3550 Layer 2 Fast Ethernet Switch
Parameters
[<portlist | all> {speed [auto | 10_half | 10_full |100_half | 100_full |
1000_full} | flow_control [enable | disable] | learning [enable |
disable] state [enable | disable]} description <desc 32>
<portlist> {description}
25
S P
WITCH ORT
5
C
OMMANDS