D-Link DES-3550 Command Line Interface Reference Manual page 226

config time_zone
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure time zone settings:
DES-3550:4#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DES-3550:4#
config dst
Used to enable and configure time adjustments to allow for the use of Daylight Savings Time
Purpose
(DST).
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat>
Syntax
| s_mth <start_mth 1-12> | s_time start_time hh:mm> | e_week <end_week 1-4,last> |
e_day <end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> |
offset [30 | 60 | 90 | 120]} | annual {s_date start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> |
e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
DST can be enabled and configured using this command. When enabled this will adjust the
Description
system clock to comply with any DST requirement. DST adjustment effects system time for both
manually configured time and time set using SNTP service.
disable - Disable the DST seasonal time adjustment for the Switch.
Parameters
repeating - Using repeating mode will enable DST seasonal time adjustment. Repeating mode
requires that the DST beginning and ending date be specified using a formula. For example,
specify to begin DST on Saturday during the second week of April and end DST on Sunday
during the last week of October.
DES-3550 Layer 2 Fast Ethernet Switch
Used to determine the time zone used in order to adjust the system clock.
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
This will adjust system clock settings according to the time zone. Time
zone settings will adjust SNTP information accordingly.
operator – Choose to add (+) or subtract (-) time to adjust for time zone
relative to GMT.
hour – Select the number of hours different from GMT.
min – Select the number of minutes difference added or subtracted to
adjust the time zone.
Only administrator-level users can issue this command.
222