D-Link DES-3550 Command Line Interface Reference Manual page 129

config bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure bandwidth control:
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure bandwidth control on a port by-port basis.
config bandwidth_control [<portlist>] {rx_rate [no_limit | <value
1-1000>] | tx_rate [no_limit<value 1-1000>]}
The config bandwidth_control command is used to configure
bandwidth on a port by-port basis.
<portlist> − Specifies a port or range of ports to be configured.
rx_rate − Specifies that one of the parameters below (no_limit or
<value 1-1000>) will be applied to the rate at which the above
specified ports will be allowed to receive packets
no_limit − Specifies that there will be no limit on the rate of
packets received by the above specified ports.
<value 1-1000> − Specifies the packet limit, in Mbps, that
the above ports will be allowed to receive.
tx_rate − Specifies that one of the parameters below (no_limit or
<value 1-1000>) will be applied to the rate at which the above
specified ports will be allowed to transmit packets.
no_limit − Specifies that there will be no limit on the rate of
packets received by the above specified ports.
<value 1-1000> − Specifies the packet limit, in Mbps, that
the above ports will be allowed to receive.
The transfer(tx) and receive(rx) rate of packets for Gigabit ports
must be configured in a multiple of 8 Mbits. (8, 16, 24...)
Only administrator-level users can issue this command.
DES-3550:4#config bandwidth_control 1-10 tx_rate 10
Command: config bandwidth_control 1-10 tx_rate 10
Success.
DES-3550:4#
125