Switch Port Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The Switch Port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
config ports
show ports
Each command is listed, in detail, in the following sections:
Parameters
[<portlist> | all] {medium_type [fiber | copper]} {speed [auto | 10_half | 10_full | 100_half
| 100_full | 1000_full {[master | slave]}] | flow_control [enable | disable] | state [enable |
disable] | learning [enable | disable] | [description <desc 32> | clear_description] | mdix
[auto | normal | cross]} (1)
{<portlist>} { [description | err_disabled] }
S
WITCH
33
6
P C
ORT OMMANDS