D-Link DES-3550 Command Line Interface Reference Manual page 199

config 802.1x init
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To initialize the authentication state machine of all ports:
DES-3550:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to initialize the 802.1x function on a range of ports.
config 802.1x init {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
port_based – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can
then be specified.
mac_based − This instructs the Switch to initialize 802.1x functions
based only on the MAC address. MAC addresses approved for
initialization can then be specified.
ports <portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Enter the MAC address to be initialized.
Only administrator-level users can issue this command.
195