D-Link DES-3550 Command Line Interface Reference Manual page 197

config 802.1x auth_parameter
Purpose Used to configure the 802.1x Authentication parameters on a range of ports. The default
parameter will return all ports in the specified range to their default 802.1x settings.
Syntax config 802.1x auth_parameter ports [<portlist> | all] [default | {direction [both | in] |
port_control [force_unauth | auto | force_auth] | quiet_period <sec 0-65535> |
tx_period <sec 1-65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-
65535> | max_req <value 1-10> | reauth_period <sec 1-65535> | enable_reauth
[enable | disable]}]
Description The config 802.1x auth_parameter command is used to configure the 802.1x
Authentication parameters on a range of ports. The default parameter will return all ports in
the specified range to their default 802.1x settings.
<portlist> − Specifies a port or range of ports to be configured.
Parameters
all − Specifies all of the ports on the Switch.
default − Returns all of the ports in the specified range to their 802.1x default settings.
direction [both | in] − Determines whether a controlled port blocks communication in both
the receiving and transmitting directions, or just the receiving direction.
port_control − Configures the administrative control over the authentication process for the
range of ports. The user has the following authentication options:
quiet_period <sec 0-65535> − Configures the time interval between authentication failure
and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a response from a supplicant
(user) to send EAP Request/Identity packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a response from a supplicant
(user) for all EAP packets, except for the Request/Identity packets.
server_timeout <sec 1-65535> - Configure the length of time to wait for a response from a
RADIUS server.
max_req <value 1-10> − Configures the number of times to retry sending packets to a
supplicant (user).
reauth_period <sec 1-65535> − Configures the time interval between successive re-
authentications.
enable_reauth [enable | disable] − Determines whether or not the Switch will re-
authenticate. Enabled causes re-authentication of users at the time interval specified in the
Re-authentication Period field, above.
Restrictions Only administrator-level users can issue this command.
DES-3550 Layer 2 Fast Ethernet Switch
force_auth − Forces the Authenticator for the port to become authorized. Network
•
access is allowed.
−
auto Allows the port's status to reflect the outcome of the authentication
•
process.
force_unauth − Forces the Authenticator for the port to become unauthorized.
•
Network access will be blocked.
193