D-Link DES-3550 Command Line Interface Reference Manual page 163

config ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IP interface System:
DES-3550:4#config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure the System IP interface.
config ipif <ipif_name 12> [{ ipaddress <network_address> [ vlan
<vlan_name 32> | state [enable | disable]} | bootp | dhcp]
This command is used to configure the System IP interface on the
Switch.
<ipif_name 12> - Enter an alphanumeric string of up to 12 characters
to identify this IP interface.
ipaddress <network_address> − IP address and netmask of the IP
interface to be created. You can specify the address and mask
information using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
<vlan_name 32> − The name of the VLAN corresponding to the
System IP interface.
state [enable | disable] − Allows you to enable or disable the IP
interface.
bootp − Allows the selection of the BOOTP protocol for the
assignment of an IP address to the Switch's System IP interface.
dhcp − Allows the selection of the DHCP protocol for the assignment
of an IP address to the Switch's System IP interface.
Only administrator-level users can issue this command.
159