Commands - D-Link DES-3550 Command Line Interface Reference Manual

The DES-3550 implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control. This
mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing
criteria for each port on the Switch that a user or network device must meet before allowing that port to forward or receive
frames.
Command
enable 802.1x
disable 802.1x
show 802.1x
auth_state
show 802.1x
auth_configuration
config 802.1x
capability ports
config 802.1x
auth_parameter
ports
config 802.1x
auth_protocol
config 802.1x init
config 802.1x
auth_mode
config 802.1x
reauth
config radius add
config radius delete
config radius
show radius
Each command is listed, in detail, in the following sections.
DES-3550 Layer 2 Fast Ethernet Switch
Parameters
{ports <portlist>}
{ports <portlist>}
[<portlist> | all] [authenticator | none]
[<portlist> | all] [default | {direction [both | in] | port_control
[force_unauth | auto | force_auth] | quiet_period <sec 0-65535> |
tx_period <sec 1-65535> | supp_timeout <sec 1-65535> |
server_timeout <sec 1-65535> | max_req <value 1-10> |
reauth_period <sec 1-65535> | enable_reauth [enable | disable]}]
[radius eap | radius pap]
{port_based ports [<portlist> | all] | mac_based [ports] [<portlist>
|all] {mac_address <macaddr>}]
[port_based | mac_based]
{port_based ports [<portlist> | all] | mac_based [ports] [<portlist>
|all] {mac_address <macaddr>}]
<server_index 1-3> <server_ip> key <passwd 32> [default |
{auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
<server_index 1-3>
<server_index 1-3> {ipaddress <server_ip> | key <passwd 32>
[auth_port <udp_port_number 1-65535> acct_port
<udp_port_number 1-65535>]}
184
802.1X C
OMMANDS
22