D-Link DES-3550 Command Line Interface Reference Manual page 146

To delete ports from a VLAN:
DES-3550:4#config vlan v1 delete 6-8
Command: config vlan v1 delete 6-8
Success.
DES-3550:4#
config gvrp
Purpose
Syntax
Description
Parameters
Restrictions
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure GVRP on the Switch.
config gvrp [<portlist> | all] {state [enable | disable] |
ingress_checking [enable | disable] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
This command is used to configure the Group VLAN Registration
Protocol on the Switch. You can configure ingress checking, the
sending and receiving of GVRP information, and the Port VLAN ID
(PVID).
<portlist> − A port or range of ports for which you want to enable
GVRP for.
all − Specifies all of the ports on the Switch.
state [enable | disable] − Enables or disables GVRP for the ports
specified in the port list.
ingress_checking [enable | disable] − Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states
the frame type that will be accepted by the Switch for this function.
tagged_only implies that only VLAN tagged frames will be accepted,
while admit_all implies tagged and untagged frames will be accepted
byt the Switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port.
Only administrator-level users can issue this command.
142