Link Aggregation Commands - D-Link DES-3550 Command Line Interface Reference Manual

The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create link_aggregation
delete link_aggregation
config link_aggregation
config link_aggregation
algorithm
show link_aggregation
config lacp_port
show lacp_port
Each command is listed, in detail, in the following sections.
DES-3550 Layer 2 Fast Ethernet Switch
L
INK
Parameters
group_id <value 1-6> {type [lacp | static]}
group_id <value 1-6>
group_id <value1-6> {master_port <port> | ports <portlist>
state [enable | disable]}
[mac_source | mac_destination | mac_source_dest | ip_source
| ip_destination | ip_source_dest]
{group_id <value 1-6> | algorithm}
<portlist> mode [active | passive]
{<portlist>}
150
A
GGREGATION
17
C
OMMANDS