D-Link DES-3550 Command Line Interface Reference Manual page 88

create syslog host
Used to create a new syslog host.
Purpose
create syslog host <index 1-4> ipaddress <ipaddr> {severity [informational | warning |
Syntax
all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enable | disable]
The create syslog host command is used to create a new syslog host.
Description
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are four
Parameters
available indexes, numbered 1 through 4.
ipaddress <ipaddr> − Specifies the IP address of the remote host where syslog messages will
be sent.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical Code
0
1
2
3
4
5
6
7
informational − Specifies that informational messages will be sent to the remote host. This
corresponds to number 6 from the list above.
warning − Specifies that warning messages will be sent to the remote host. This corresponds
to number 4 from the list above.
all − Specifies that all of the currently supported syslog messages that are generated by the
Switch will be sent to the remote host.
facility − Some of the operating system daemons and processes have been assigned Facility
values. Processes and daemons that have not been explicitly assigned a Facility may use any
of the"local use" facilities or they may use the "user-level" Facility. Those Facilities that have
been designated are shown in the following: Bold font indicates the facility values that the
Switch currently supports.
Parameters Numerical Code Facility
0
1
2
3
4
5
6
7
8
9
10
11
DES-3550 Layer 2 Fast Ethernet Switch
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
kernel messages
user-level messages
mail system
system daemons
security/authorization messages
messages generated internally by syslog
line printer subsystem
network news subsystem
UUCP subsystem
clock daemon
security|authorization messages
FTP daemon
Numerical Code Facility
12
13
14
15
16
17
18
19
20
21
22
23
84
NTP subsystem
log audit
log alert
clock daemon
local use 0 (local0)
local use 1 (local1)
local use 2 (local2)
local use 3 (local3)
local use 4 (local4)
local use 5 (local5)
local use 6 (local6)
local use 7 (local7)