config access_profile
ip − Specifies that the Switch will look into the IP fields in each packet.
Parameters
vlan <vlan_name 32> − Specifies that the access profile will apply to only this VLAN.
•
source_ip <ipaddr> − Specifies that the access profile will apply to only packets with this
•
source IP address.
destination_id <value 0-255> − Specifies that the access profile will apply to only packets
•
with this destination IP address.
dscp <value 0-63> − Specifies that the access profile will apply only to packets that have this
•
value in their Type-of-Service (DiffServ code point, DSCP) field in their IP packet header
icmp − Specifies that the Switch will examine the Internet Control Message Protocol (ICMP)
•
field within each packet.
igmp − Specifies that the Switch will examine the Internet Group Management Protocol
•
(IGMP) field within each packet.
tcp − Specifies that the Switch will examine the Transmission Control Protocol (TCP) field
•
within each packet.
src_port <value 0-65535> − Specifies that the access profile will apply only to packets that
•
have this TCP source port in their TCP header.
dst_port <value 0-65535> − Specifies that the access profile will apply only to packets that
•
have this TCP destination port in their TCP header.
flag_mask – Enter the type of TCP flag to be masked.
•
src_port <value 0-65535> − Specifies that the access profile will apply only to packets that
•
have this UDP source port in their header.
dst_port <value 0-65535> − Specifies that the access profile will apply only to packets that
•
have this UDP destination port in their header.
protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field in each
•
packet and if this field contains the value entered here, apply the following rules.
DES-3550 Layer 2 Fast Ethernet Switch
type <value 0-65535> − Specifies that the access profile will apply to this ICMP type
•
value.
code <value 0-255> − Specifies that the access profile will apply to this ICMP code.
•
type <value 0-255> − Specifies that the access profile will apply to packets that have
•
this IGMP type value.
all: all flags are selected.
•
urg: TCP control flag (urgent)
•
ack: TCP control flag (acknowledgement)
•
psh: TCP control flag (push)
•
rst: TCP control flag (reset)
•
syn: TCP control flag (synchronize)
•
fin: TCP control flag (finish)
•
udp − Specifies that the Switch will examine the Universal Datagram Protocol (UDP)
•
field in each packet.
209