D-Link DES-3550 Command Line Interface Reference Manual page 90

config syslog host
Used to configure the syslog protocol to send system log data to a remote host.
Purpose
config syslog host [all | <index 1-4>] {severity [informational | warning | all] |
Syntax
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable | disable]
The config syslog host command is used to configure the syslog protocol to send system log
Description
information to a remote host.
Parameters <index 1-4> − Specifies that the command will be applied to an index of hosts. There are four
available indexes, numbered 1 through 4.
ipaddress <ipaddr> − Specifies the IP address of the remote host where syslog messages will
be sent.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical Code
0
1
2
3
4
5
6
7
informational − Specifies that informational messages will be sent to the remote host. This
corresponds to number 6 from the list above.
warning − Specifies that warning messages will be sent to the remote host. This corresponds
to number 4 from the list above.
all − Specifies that all of the currently supported syslog messages that are generated by the
Switch will be sent to the remote host.
facility − Some of the operating system daemons and processes have been assigned Facility
values. Processes and daemons that have not been explicitly assigned a Facility may use any
of the"local use" facilities or they may use the "user-level" Facility. Those Facilities that have
been designated are shown in the following: Bold font indicates the facility values the Switch
currently supports.
DES-3550 Layer 2 Fast Ethernet Switch
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
86