D-Link DES-3550 Command Line Interface Reference Manual page 218

config traffic_segmentation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3550:4# config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure traffic segmentation on the Switch.
config traffic_segmentation [<portlist>] forward_list [null |
<portlist>]
The config traffic_segmentation command is used to configure traffic
segmentation on the Switch.
<portlist> − Specifies a port or range of ports that will be configured
for traffic segmentation.
forward_list − Specifies a range of ports that will receive forwarded
frames from the ports specified in the portlist, above.
• null − No ports are specified
• <portlist> − Specifies a range of ports for the forwarding
list. This list must be on the same Switch previously
specified for traffic segmentation (i.e. following the
<portlist> specified above for config traffic_segmentation).
Only administrator-level users can issue this command.
214