D-Link DES-3550 Command Line Interface Reference Manual page 177

config limited multicast address
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the limited multicast address on ports 1-3:
DES-3550:4#config limited multicast address 1-3 from 224.1.1.1 to 224.1.1.2 access permit state enable
Command: config limited multicast address 1-3 from 224.1.1.1 to 224.1.1.2 access permit state enable
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure limited IP multicast address range.
config limited multicast address <portlist> {from <multicast_ipaddr> to
<multicast_ipaddr> access [permit | deny] | state [enable | disable]}
The config limited multicast address command allows the user to configure the
multicast address range, access level, and state.
<portlist> A port or range of ports to config the limited multicast address.
from Enter the lowest multicast IP address of the range.
to Enter the highest multicast IP address of the range.
access Use the access field to either permit or deny to limit or grant access to a
specified range of Multicast addresses on a particular port or range of ports.
state This parameter allows the user to enable or disable the limited multicast
address range on a specific port or range of ports.
Only administrator-level users can issue this command.
173