D-Link DES-3550 Command Line Interface Reference Manual page 231

Example usage:
To config address binding on the switch:
DES-3550:4# config address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-00-05
Command: config address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-00-05
Success.
DES-3550:4#
config address_binding ip_mac ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config address binding on the switch:
DES-3550:4# config address_binding ip_mac ports 2 state enable
Command: config address_binding ip_mac ports 2 state enable
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure an IP-MAC state to enable or disable for specified ports.
config address_binding ip_mac ports [ <portlist> | all ]
state [ enable | disable]
This command is used to enable disable IP-MAC binding for specified ports.
The IP-MAC binding entry applies only to the specified port or ports.
<portlist> − Specifies a port or range of ports.
all – Specifies all ports on the switch.
state [ enable | disable ] – Enables or disables IP-MAC binding for the specified
range of ports. When enabled the IP-MAC binding comparison is applied to
traffic (ARP packets) through the specified ports.
Only administrator-level users can issue this command.
227