D-Link DES-3550 Command Line Interface Reference Manual page 209

create access_profile
ip − Specifies that the Switch will examine the IP address in each frame's header.
Parameters
vlan − Specifies a VLAN mask.
•
source_ip_mask <netmask> − Specifies an IP address mask for the source IP address.
•
destination_ip_mask <netmask> − Specifies an IP address mask for the destination IP
•
address. |
dscp − Specifies that the Switch will examine the DiffServ Code Point (DSCP) field in each
•
frame's header.
icmp − Specifies that the Switch will examine the Internet Control Message Protocol (ICMP)
•
field in each frame's header.
type − Specifies that the Switch will examine each frame's ICMP Type field.
•
code − Specifies that the Switch will examine each frame's ICMP Code field.
•
igmp − Specifies that the Switch will examine each frame's Internet Group Management
•
Protocol (IGMP) field.
type − Specifies that the Switch will examine each frame's IGMP Type field.
•
tcp − Specifies that the Switch will examine each frames Transport Control Protocol (TCP)
•
field.
src_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the source port.
•
dst_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the destination port.
•
flag_mask – Enter the appropriate flag_mask parameter. All incoming packets have TCP
•
port numbers contained in them as the forwarding criterion. These numbers have flag bits
asscociated with them which are parts of a packet that determine what to do with the
packet. The user may deny packets by denying certain flag bits within the packets. The user
may choose between all, urg (urgent), ack (acknowledgement), psh (push), rst (reset), syn
(synchronize) and fin (finish).
udp − Specifies that the Switch will examine each frame's Universal Datagram Protocol
•
(UDP) field.
src_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the source port
•
dst_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the destination port.
•
protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field in each
•
packet and if this field contains the value entered here, apply the following rules
user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to the IP protocol ID
•
and the mask options behind the IP header.
DES-3550 Layer 2 Fast Ethernet Switch
205