Blur Settings - Sony DVS-9000 User Manual

5
Masking the Defocus effect with a selected pattern
Press [Mask] to display the Mask menu, and set the pattern type and modifiers.
For details, see "Mask Settings" (page 68).

Blur Settings

This effect blurs the entire image.
Applying the Blur effect
1
2
3
4
54
DME Special Effect Operations
Knob Parameter Adjustment
1 H Horizontal defocusing of key
signal
2 V Vertical defocusing of key signal 0.00 to 100.00
3 All Horizontal and vertical
defocusing of key signal
To cancel black level leaking that can occur at the edge of the screen when
the Defocus effect is enabled, press [Clean Defocus], turning it on.
In the DME menu, select VF2 'Video Modify' and HF1 'Defocus/Blur.'
The Defocus/Blur menu appears.
Press [Blur], turning it on.
The Blur effect is enabled. You can adjust the blurring of video and key
signals with the knobs.
Note
On the MVE-8000A, the Glow and Blur effects cannot be enabled at the
same time. The effect which was turned on most recently is enabled.
When the MVE-8000A/MVE-9000 is connected through an SDI interface,
in the <Blur Mode> group, select the signal to which you want apply the
Blur effect.
Video/Key: Video signal and key signal
Video: Video signal only
Key: Key signal only
Set the parameters.
Settings values
0.00 to 100.00
H value shown