Hydraulic Steer Unit Removal And Replacement - jcb 214e Service Manual

www.WorkshopManuals.co.uk
Section H
50 - 1
Removal and Replacement
Removal
!
DANGER
Hydraulic Pressure
Hydraulic fluid at system pressure can injure you. Before
disconnecting or connecting hydraulic hoses, stop the
engine and operate the controls to release pressure
trapped in the hoses. Make sure the engine cannot be
started while the hoses are open.
INT-3-1-11/1
1 Park the machine on level ground, engage the parking
brake and set the transmission to neutral. Lower the
at t ac hment s t o t he ground . St op t he engine and
remove the starter key.
2 Turn the steering wheel to the left and to the right
several times to vent system pressure.
Disc onnec t and c ap all hyd raulic hoses from t he
3
steering unit as shown at A. Label the hoses to ensure
correct refitting.
4 Get an assistant to hold the steering unit, and, working
inside the cab, loosen and remove 4 bolts B. Lift the
steering unit from the machine.
A
9803/3280
Hydraulic Steer Unit
Purchased from www.WorkshopManuals.co.uk
Steering
Replacement
Fine jets of hydraulic fluid at high pressure can penetrate
the skin. Do not use your fingers to check for hydraulic
fluid leaks. Do not put your face close to suspected
leaks. Hold a piece of cardboard close to suspected
leaks and then inspect the cardboard for signs of
hydraulic fluid. If hydraulic fluid penetrates your skin, get
medical help immediately.
INT-3-1-10/1
Replacement is a reversal of the removal sequence.
1
Make sure that the hoses are correctly installed.
2 B leed t he st eering syst em . Ref er t o Se rvic e
Procedures, Steering System - Bleeding.
3 If a new steering unit has been fitted then the system
relief valve must be tested for correct pressure setting.
Refer to Service Procedures, Steering System -
Pressure Testing.
Note: All hydraulic adapters that are installed together with a
bonded sealing washer must also have JCB Threadseal
applied to the threads of the adapter.
Section H
! WARNING
B
50 - 1
A390610
Issue 1