Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section F
127 - 14
11
Fit the Solenoid Control Valve Block
a
Fit two guide studs at the valve interface on the front
case. Locate a new valve block sealing gasket 11a as
shown at C. Care is needed as the gasket is thin.
Gearboxes fitted with a sub-base plate have two
gaskets, one each side of the plate.
b
Fit the 8 socket head cap screws and washers 11b. The
screws must be progressively torque tightened.
Gradually tighten all the screws to 35 Nm (26 lbf ft).
12
Fit the Main Hydraulic Pump Driveshaft
a
Fit a new sealing ring 12a to the shaft 12b. Apply clean
oil to the sealing ring and fit the shaft inside the gearbox.
b
Apply clean oil to the ball bearing 12c. Fit the bearing
followed by circlip 12d.
13
Fit the Layshaft Cover
a
If applicable fit the layshaft cover 13a. Make sure the
casing mating faces are clean and undamaged. Apply a
thin bead of JCB Multigasket to the rear casing and fit
the cover. Fit bolts 13b and progressively torque tighten
to 56Nm (41 lbf ft).
Note: The main machine hydraulic pump can be fitted at this
stage. However, it is easier to fit the gearbox to the machine
and then fit the pump. See Section E, Main Hydraulic
Pump, Replacement.
9803/3280
Transmission
Powershift Gearbox
Purchased from www.WorkshopManuals.co.uk
Section F
127 - 14
Issue 1
Advertisement
Table of Contents
