Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section F
81 - 4
Hub and Driveshaft - Dismantling (cont'd)
14
Pull off the inner bearing - see Note at step 13.
15
Remove and discard the seal.
Note: The inner bearing and oil seal may withdraw with the
bearing carrier.
16
Remove and discard the combination seal. When
assembling the axle, a new combination seal must be
used.
17
Mark position of top and bottom trunnions H and
remove. Withdraw the hub carrier.
Note 1: Trunnions may be removed easily by pumping
grease through the grease nipple.
18
Use ad ap t o r 993/ 59500 w it h slid e ham m er t o o l
892/00224 and remove driveshaft seal and needle roller
bearing from the hub carrier.
9803/3280
Transmission
Front Axle - SD55, SD70
Purchased from www.WorkshopManuals.co.uk
Section F
S258260
S248880
H
H
S248890
S161460
81 - 4
Issue 1
Advertisement
Table of Contents
