Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section B
40 - 1
Removal and Replacement
Removal
Park the machine on firm level ground, engage the
1
parking brake and set the transmission to neutral.
Lower the loader arms to the ground.
2
Position the carriage in the central protruding travel
position at 150 mm (6 in) from end of the rail, rest the
bucket on the ground and remove the starter key.
3
Operate control levers to vent hydraulic pressure.
4
Disconnect hydraulic hoses A and plug.
5
Disconnect all four chains at adjusters B and disengage
chains from ram pulleys.
6
Remove pin C from one end and support the ram.
7
Remove pin C from opposite end, withdraw ram.
E D
B
9803/3280
Body & Framework
Power Sideshift Ram
C
Purchased from www.WorkshopManuals.co.uk
Replacement
Locate the ram at one end with pin C. Adjust the ram
1
eye end so the the opposite end of the ram aligns with
mounting bracket.
2
Secure the opposite end of the ram in position with pin
C.
3
With a spanner on the rod end flats D adjust the rod so
that the ram eye end engagement is equal at each end
of the ram. Lock eye ends in position with nut E.
4
Reconnect the hydraulic hoses.
5
Locate the chains around the applicable ram pulleys.
Reconnect chains and adjust as required, refer to
Service Procedures, Power Sideshift - Chain
Adjustment.
A
Section B
40 - 1
A326850
Issue 1
Advertisement
Table of Contents
