jcb 214e Service Manual page 619

www.WorkshopManuals.co.uk
Section F
35 - 3
Synchro Shuttle Gearbox (cont'd)
CHECK
33 Are the selector rods worn or damaged?
34 Are the selector fork pads out of position?
Is there excessive end float in gears or shafts?
35
36 Is the synchroniser bronze worn?
37 Are steel chips embedded in the bronze?
38 Are the synchroniser components damaged?
39 Are the sliding gears tight on the splines?
40 Are chips wedged between splines of shaft
or gear?
41 Are steel chips embedded in the bronze?
42 Are the synchroniser spring pins damaged?
Is the synchroniser bronze worn?
43
9803/3280
Transmission
Fault Finding
Purchased from www.WorkshopManuals.co.uk
ACTION
YES: Renew.
NO: Check 34
YES: Reposition or renew (check interlock).
NO: Check 35
YES: Adjust.
NO: Check thrust washers and mating faces.
YES: Renew synchro pack.
NO: Check 37
YES: Continue using, chips will either embed below bronze
or be rejected.
NO: Check 38
YES: Renew.
NO: Check free running gears for seizure or damage.
YES: Free or renew.
NO: Check 40
YES: Remove chips.
NO: Ensure that clutch is disengaged when dump pedal is
pressed.
YES: Continue using, chips will either embed below bronze
or be rejected.
NO: Check 42
YES: Renew synchro.
NO: Check 43
YES: Renew synchro.
NO: Check blocker pins.
Section F
35 - 3
Issue 1