Synchro Shuttle Gearbox Assembly; Bearing Setting Rings - jcb 214e Service Manual

Backhoe loader

Hide thumbs Also See for 214e:

Table of Contents

www.WorkshopManuals.co.uk

If the bearing outer cups and setting rings have been

removed, fit new rings so that they are flush with the outer

face of case as shown at A. Press in the outer bearing cups

from the inside of the casing as shown at B. Push in the cup

until it is up against the setting ring.

If the gearbox casings are to be renewed, be sure to fit

blanking plugs and adapters as required. Inspect the original

casings and identify the blanking plug and adapter positions.

Transfer the plugs and adapters to the new casings. Apply

JCB Threadlocker and Sealer to the threads.

Note that new plugs may be supplied with a sealant 'patch',

in which case sealant need not be applied. Torque tighten

plugs to 25 - 28 Nm (18.4 - 20 lbf ft).

Before fitting adapter C, be sure to fit the orifice restrictor

inside the port.

Transmission

Synchro Shuttle Gearbox

Purchased from www.WorkshopManuals.co.uk

4cx 3cx 214 215 217