Engine Air Filter Maintenance; Changing The Elements - jcb 214e Service Manual

Backhoe loader

Hide thumbs Also See for 214e:

Table of Contents

www.WorkshopManuals.co.uk

The outer element must be renewed immediately if the

warning light on the instrument panel illuminates.

Note: Do not attempt to wash or clean the elements - they

must only be renewed.

Note: Do not run the engine with the dust valve J removed.

Note: A new inner element must be fitted at least every third

time the outer element is changed. As a reminder, mark the

inner element with a felt tipped pen each time the outer

element is changed.

Stop the engine.

Remove the engine side panel (left hand side).

If changing the inner element, cover the end of the hose

to prevent rain and dirt from getting into the engine.

Routine Maintenance

Engine Air Filter

Purchased from www.WorkshopManuals.co.uk

Depress clips B and lift off cover C. Remove outer

element D. Take care not to tap or knock the element. If

the inner element is to be changed, lift up pulls E and

remove inner element F. On turbocharged engines,

remove pulsation ring L.

Clean inside the canister H, pulsation ring L, cover C

and dust valve J.

Insert the new elements into the canister, pushing them

firmly in so that seals G and K are fully seated. On

turbocharged engines, assemble the pulsation ring L

into the cover, making sure that tongue M fits into slot

N. Fit cover C with dust valve J at the bottom. Push the

cover firmly into position and make sure it is secured by

Note: Pulsation ring L is not fitted in this application.

Refit the induction hose to stub pipe A. Make sure that

the wire is connected to the Air Filter Blocked switch.

4cx 3cx 214 215 217