Powershift Gearbox - 6 Speed: Shiftmaster Diagnostics - User Guide; Installing Shiftmaster Diagnostics - jcb 214e Service Manual

www.WorkshopManuals.co.uk
Section F
69 - 1
Powershift Gearbox - 6 speed
ShiftMaster Diagnostics - User Guide
1. Introduction
ShiftMaster Diagnostics software is a PC based
Diagnostics Tool designed to be an easy to use fault finding
tool for the Service Engineer using a laptop PC. ShiftMaster
Diagnostics employs the graphical strengths of the
Microsoft Windows operating environment to simplify
electrical fault finding within the ShiftMaster ECU control
system used on Powershift PS766 6 speed gearboxes.
ShiftMaster Diagnostics is only intended for use with the
ShiftMaster ECU and does not support older versions of
Powershift Controllers used on the PS750 series gearboxes.
To utilise any supporting ShiftMaster Service Tools requires
the use of the JCB Data Link Adaptor [or DLA] (717/ 20138)
which is part of the standard JCB Electronic Service Tool
Kit, part number 892/01033.
This software is intended for use on IBM Compatible
Personal Computers (PCs) running Windows 9x or
Windows2000 operating systems but is not compatible with
either earlier versions of Windows 3.x.
All distributed software can be found on Disk 3 (CD3 -
Adobe) of the JCB Technical Information Parts and Service
CD-ROM set from Issue 19 onwards. This disk is also
supplied as part of the Electronic Service Tool Kit. Copies of
this CD-ROM can be purchased from JCB Service.
Alternatively, in due course software will become available
for download over the internet via JCBs' Techweb service.
Please refer to the available software for full installation
instructions.
9803/3280
Transmission
Service Procedures
S404170
Purchased from www.WorkshopManuals.co.uk
2. Care & Safety
! WARNING
Be sure to read and follow any on-screen instructions
issued by ShiftMaster Diagnostics. Failure to follow
correct procedure could result in death or injury.

3. Installing ShiftMaster Diagnostics

The ShiftMaster Diagnostics tool is fully integrated within
JCB ServiceMaster.
For full instructions on how to install the ShiftMaster
Diagnostics software please refer to the documentation
which accompanies JCB Service Master.
If you have successfully installed ShiftMaster Diagnostics
but are experiencing difficulties with getting your PC to
communicate with an ECU then there is a Troubleshooting
Guide built into the ShiftMaster Diagnostics Help menu.
Section F
69 - 1
S404180
Issue 1