Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section D
31 - 2
214e Machines Only
The shovel reset system is designed to automatically tilt the
shovel forward when the loader arms are raised, this
prevents a heaped shovel from depositing its contents over
the back of the shovel onto the bonnet or cab when the
loader arms are raised.
When the loader arms are raised the feed back link A causes
the cam plate B to rotate anti-clockwise. The rotation of the
cam plate pulls the cable C which selects the loader valve
block shovel spool D to tip the shovel forwards.
When either a cable or feedback link is changed or if the
shovel reset system is not operating correctly carry out
functional adjustment check.
D
C
9803/3280
Shovel Reset
B
A
A320500
Purchased from www.WorkshopManuals.co.uk
Controls
Fitting
1
Adjust the feedback link A to 2065mm (81.3in). After
adjusting tighten the lock nuts.
2
Fit cam plate B with the single threaded hole at the top.
3
Fit feed back link A to cam plate and shovel lever E.
4
Connect cable C to the bottom centre position F on the
cam plate B, secure in position.
Note: The factory fit position for the cable end ball joint to
cam plate is the centre position. Because of component
variation it is permissible to fit the cable end ball joint in
either the forward or rear position. The forward position will
advance the levelling and the rear position will delay the
levelling.
5
Connect cable C to the loader arm control lever G.
6
Secure cable ends with spring clips H.
7
Carry out the adjustment procedure.
Adjustment
1
Roll the shovel fully back and lower to the ground.
2
The feedback link position in relation to the loader arm
pivot pin measurement J should be 40mm (1.5in).
Adjust feedback link as required.
3
When the loader arms are raised there should be no
slack in the cable at K when the shovel arm pivot pin L
is 1.0 to 1.5 meters (3.5 to 5.0 feet).
4
Roll the shovel fully forward and fully retract the lift
arms, this will raise the front wheels off the ground.
5
In this position there should be slack in the cable at M,
if not adjust the cable as required.
Note: Whenever any adjustment is made repeat steps 4/5 to
make sure there is slack in the cable with the shovel rolled
fully forward.
Section D
31 - 2
Issue 1
Advertisement
Table of Contents
