Crownwheel And Pinion Meshing (Rear Axle - Sd80, Pd70) - jcb 214e Service Manual

www.WorkshopManuals.co.uk
Section F
94 - 8
Crownwheel and Pinion Meshing
Meshing of the gears should be checked by marking three of
the pinion teeth with engineers marking compound and
rotating the pinion.
The marking will then be transferred to the crown wheel
teeth.
Correct tooth marking.
Pinion too deeply in mesh.
Decrease the shim thickness between the pinion inner
bearing cup and the axle casing. Move the crown wheel
towards the pinion to correct the backlash.
Pinion too far out of mesh.
Increase the shim thickness between the pinion inner
bearing cup and the axle casing. Move the crown wheel
away from the pinion to correct the backlash.
9803/3280
Transmission
Rear Axle - SD80, PD70
Purchased from www.WorkshopManuals.co.uk
Section F
94 - 8
A386940
A386950
A386960
Issue 1