Auxiliary Footpedal Cable - jcb 214e Service Manual

Backhoe loader

Hide thumbs Also See for 214e:

Table of Contents

www.WorkshopManuals.co.uk

Removal and Replacement

Auxiliary Footpedal Cable

The auxiliary footpedal control A is mounted in the cab floor

as shown. The cable operates the auxiliary control valve

located adjacent to the excavator valve. The cable is

accessible underneath the rear L.H. corner of the cab.

Note the routing of the existing cable and route the new

cable in the same way.

Park the machine on firm level ground, apply the

parking brake. Lower the loader arms and excavator to

the ground, switch OFF the engine and remove the

starter key.

Working at the rear of the machine at the auxiliary valve,

undo the locknut B. Remove the screws C and slide

back the housing D to reveal the clevis as shown.

Remove the clevis pin E to release the cable.

At the footpedal remove the U-clamp F securing the

cable to the bracket. Remove the spring clip G to

release the cable. If the cable is to be replaced, remove

and retain the microswitch operating tab H from the old

cable as shown.

Replacement is the reverse of the removal sequence.

Control Cables

Purchased from www.WorkshopManuals.co.uk

4cx 3cx 214 215 217